Lift cables carry serious load alongside the springs. When one frays or snaps, we replace both cables as a pair and check the drums for wear.
Matching wear on both cables means both get inspected and typically replaced together.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
A same-day fix is standard for cable failures, parts already on the truck.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We replace the snapped cable and its pair, then verify even tension across both sides.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Cable stock on the truck means most calls avoid a second trip for parts.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Clifton to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Clifton, NJ